BMSSJ - N4760 1LT BLUE TREE MARKING PAINT
- MSDS: BMSSJ
- Manufacturer: NILES CHEMICAL PAINT
- Product Name: N4760 1LT BLUE TREE MARKING PAINT
- National Stock Number: 8010-01-274-2573
Product Identification
Product ID:N4760 1LT BLUE TREE MARKING PAINT
MSDS Date:10/31/1991
FSC:8010
NIIN:01-274-2573
MSDS Number: BMSSJ
Responsible Party
NILES, MI 49120
US
Emergency Phone: 219-236-5856
Info Phone: 616-683-3377
Preparer: MIKE LICHATOWICH
Cage: 02388
Contractor
Telephone: 616-683-3377/219-236-5856
Cage: 02388
Ingredients
MINERAL SPIRITS (VP 2.0 MM @ 20 C)
CAS: 8052-41-3
Fraction By Weight: 48%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM; 9293
ALKYD RESIN
Fraction By Weight: 20%
COBALT COMPOUNDS (AS CO)(SARA 313)
CAS: 7440-48-4
Fraction By Weight: <1%
OSHA PEL 0.1 MG/M3;AS CO
ACGIH TLV: 0.05 MG/M3;DUST 9293
MANGANESE COMPOUNDS (AS MN)(SARA 313)
CAS: 7439-96-5
Fraction By Weight: <1%
OSHA PEL (C) 5 MG/M3 DUST
ACGIH TLV: 5 MG/M3 DUST 9293
PROPRIETARY INGREDIENTS
Fraction By Weight: BALANCE
4.35 LBS/GAL
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES- SEVERE IRRITATION, LACRIMATION,
REDNESS, BLURRED VISION, VISUAL DISTURBANCES & EYE BURNS. SKIN-
HARMFUL IF ABSORBED THROUGH SKIN. CAN BE ABSORBED IN TOXIC AMOUNTS,
ESPECIALLY FROM PROLONGED OR R EPEATED EXPOSURES. BREATHING- NASAL
& RESPIRATORY IRRITATION, CNS DEPRESSION (DIZZINESS, DROWSINESS,
WEAKNESS, FATIGUE,*
Effects of Overexposure:*CONFUSION) NAUSEA, HEADACHE, VERTIGO, POSSIBLE
UNCONSCIOUSNESS, EVEN ASPHYXIATION. SWALLOWING- GASTROINTESTINAL
IRRITATION, ABDOMINAL PAIN, NAUSEA, VOMITING, DIARRHEA, BLINDNESS &
EVEN DEATH. TARGET ORGANS- SKIN, EYES, RESPIRATORY SYSTEM,CNS, GI
TRACT.
First Aid
First Aid:INHALE-MOVE TO FRESH AIR. IF BREATHING STOPPED, GIVE CPR. GET
MED AID ASAP. SKIN- WASH W/SOAP/WATER. EYE: IMMED FLUSH W/LG AMT
WATER-15 MIN, OCCASIONALLY LIFTING UPPER/LOWER LIDS. GET MED AID
IMMED. C ONTACT LENSES SHOULD NOT BE WORN WHEN WORKING W/THIS
MAT'L. SWALLOWING- INDUCE VOMIT IMMED BY GIVING 2 GLASSES WATER &
STICKING FINGER DOWN THROAT. NOTHING BY MOUTH UNCONSC PERSON. GET
MED AID IMMED.
Fire Fighting
Flash Point Method:TCC
Flash Point:102F,39C
Lower Limits:36.0
Upper Limits:0.8
Extinguishing Media:DRY CHEMICAL, FOAM, CO2.
Fire Fighting Procedures:WEAR SCBA W/FULL FACEPIECE OPERATED IN
POSITIVE PRESS MODE & FULL PROTECT CLOTH. USE WATER TO COOL CLOSED
CNTNR(PREVENT PRESS BUILD-UP & POSS AUTOIGNITE)W/HEAT.
Unusual Fire/Explosion Hazard:KEEP CNTNRS CLOSED TIGHT & FROM IGNITE
SOURCES. CLOSED CNTNRS MAY EXPLODE W/EXTREME HEAT, USE CAUTION.
OVEREXPOS TO DECOMP PROD MAY CAUSE HEALTH HZD.
Accidental Release
Spill Release Procedures:REMOVE IGNITE SOURCES. MINIMIZE BREATHING OF
VAP & AVOID SKIN CNTCT. SMALL-ABSORB W/INERT MAT'L. SHOVEL
RECLAIMED LIQ & ABSORB TO RECOVERY/SALVAGE DRUMS FOR DISPOSAL.
LG-DIKE TO PREVENT FURTHER MOVEME NT & RECLAIM TO RECOVERY/SALVAGE
DRUMS/TANK TRUCK.
Handling
Handling and Storage Precautions:AVOID STORAGE IN HIGH TEMPERATURES
AREAS OR NEAR FIRE OR OPEN FLAME. KEEP CONTAINERS CLOSED WHEN NOT
IN USE. AVOID ROUGH HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMTPY DRUMS.
Exposure Controls
Respiratory Protection:WEAR APPROP (TYPE TC-23C-75) PROPERLY FITTED
HALF-MASK OR FULL FACEPIECE RSPRTR (NIOSH/MSHA) DURING & AFTER
APPLIC UNLESS AIR MONITORING DEMONSTRATES VAPOR/MIST LEVELS ARE
BELOW APPLICABLE LIMITS. FOL LOW RESPIRATOR MFR DIRECTIONS FOR USE.
Ventilation:PROVIDE SUFFIC VENT IN VOLUME/PATTERN TO KEEP AIR CONC
BELOW CURRENT APPLICABLE OSHA PERMISSIBLE EXPOSURE LIMIT OR **
Protective Gloves:CHEMICAL RESISTANT (NITRILE OR VITON)
Eye Protection:CHEM GOGGLES, SFTY GLASSES, FACE SHIELD
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING OR USING
RESTROOM.
Supplemental Safety and Health
WASH SKIN PROMPTLY IF CONTAM. REMOVE ANY CLOTHING THAT BECOMES WET (TO
AVOID FLAMM HZD). SYMPTOMS FROM USE MAY NOT BE IMMED APPARENT. GET
MEDICAL AID. **ACGIH'S TLV LIMIT. REMOVE DECOMP PRODUCTS FORME D
DURING WELDING OR FLAME CUTTING SURFACES COATED W/THIS PRODUCT. FOR
BAKING FINISHES-VENT VAPORS EMITTED ON HEATING.
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:146 TO 330F
Vapor Density:> AIR
Spec Gravity:8.90 LB/GL
Viscosity:40-45SZ#2
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, ODOR OF SOLVENTS.
Percent Volatiles by Volume:68.59
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:HIGH TEMPERATURES, SHOCK FROM DROPPING.
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND/OR
CARBON DIOXIDE.
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH APPLICABLE LOCAL,
STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.